The Chamberlain Original Clicker Keypad is a popular and reliable remote control system designed to make operating your garage door easier and more convenient. This manual and setup guide will walk you through the steps to properly install, program, and use your Chamberlain Original Clicker Keypad.
Why Use a Chamberlain Original Clicker Keypad?
A Chamberlain Original Clicker Keypad offers numerous benefits, including:
- Convenience: Open and close your garage door from anywhere within range of the keypad, without the need for a physical remote control.
- Security: Use a unique four-digit code to secure your garage door and prevent unauthorized access.
- Ease of use: Simple and intuitive design makes it easy to program and operate the keypad.
Before You Begin
Before setting up your Chamberlain Original Clicker Keypad, make sure you have the following:
- The keypad itself
- A Chamberlain garage door opener (compatible models include 950CB, 953CB, 940CB, and 943CB)
- A battery (9-volt, included with the keypad)
- A screwdriver (for mounting the keypad)
Step 1: Mounting the Keypad
To mount the keypad, follow these steps:
- Choose a location for the keypad, ideally near the garage door and at a comfortable viewing height.
- Use a screwdriver to mark the screw holes on the wall.
- Drill pilot holes for the screws.
- Mount the keypad using the provided screws.
Step 2: Programming the Keypad
To program the keypad, follow these steps:
Programming the Keypad
- Enter the factory-set code (default code: 0-0-0-0).
- Press the "Prog" button until the LED light flashes.
- Enter your new four-digit code.
- Press the "Prog" button again to confirm.
- Test the keypad by entering your new code and pressing the "Enter" button.
Step 3: Syncing the Keypad with the Garage Door Opener
To sync the keypad with the garage door opener, follow these steps:
Syncing the Keypad with the Garage Door Opener
- Press and hold the "Prog" button on the keypad until the LED light flashes.
- Release the "Prog" button and immediately press the "Learn" button on the garage door opener.
- The garage door opener will flash its lights to indicate that it is in learn mode.
- Press the "Enter" button on the keypad to complete the syncing process.
Using the Keypad
To use the keypad, simply enter your four-digit code and press the "Enter" button. The garage door will open or close accordingly.
Troubleshooting
If you encounter any issues with your Chamberlain Original Clicker Keypad, refer to the troubleshooting guide below:
- Keypad not responding: Check the battery level and replace if necessary.
- Incorrect code: Try re-entering the code or resetting the keypad.
- Keypad not syncing with garage door opener: Check the garage door opener's compatibility and try re-syncing the keypad.
Gallery of Chamberlain Original Clicker Keypad
Frequently Asked Questions
What is the default code for the Chamberlain Original Clicker Keypad?
+The default code for the Chamberlain Original Clicker Keypad is 0-0-0-0.
How do I reset the keypad?
+To reset the keypad, press and hold the "Prog" button until the LED light flashes, then release and immediately press the "Prog" button again.
Is the Chamberlain Original Clicker Keypad compatible with all garage door openers?
+No, the Chamberlain Original Clicker Keypad is only compatible with certain Chamberlain garage door openers (950CB, 953CB, 940CB, and 943CB).
We hope this manual and setup guide has been helpful in getting you started with your Chamberlain Original Clicker Keypad. If you have any further questions or concerns, please don't hesitate to reach out.